rq-sssp-client-1.02 ***CS 4k only*** * Added support for a proprietary SSSP protocol to be used with the modified RQ Coolsat firmwares. Only Coolsat 4000 is supported right now (firmware is included in this release), 5000 and 6000 coming soon.
* IMPORTANT: Do not use byte_write_delay=0. Be sure to use the configuration file default of 200us, otherwise you might get unreliable communication on Coolsat receivers.
* Added support for the Gbox SSSP protocol variant. Allows support for Digiwave (with Satywave firmware), Technomate and many other brands of EU receivers. As of this release, the protocol is implemented but UNTESTED. Please try it and report your results.
* Added an option for returning either the even or odd control word for each ECM. This is intended as a fix for freezing on some receivers when using NDS providers. Review the configuration file for details.
* Modified start-up behavior so that if failure to connect occurs, the client starts anyway so it can attempt to connect later on.
* Increased CW timeout to 14 seconds.
* Added the ECM response time in milliseconds to the console logs.

The new Fix. Unzip the file before loading.
Load the new file and set auto roll to "ON" and wait up to 15 min for the keys to auto roll.

Make sure that the Auto Roll feature is turned "ON." You will find the Auto Roll feature in the Menu options.

If you don't have the picture after 15min Reboot your system using the switch at the back of the receiver.
Click here for the troubleshooting guide.
* Change*
( Main software upgrade )

- AR Fixed

Note:
- Do a hard reboot (power OFF-ON using rear switch) after every update.

Attached Files

rq-sssp-client-1.02 CS 4k only.zip (1.18 MB, 32 views)

__________________