Hello, I have an nfusion nuvenio hd, 39" dish, monster quad lnb. uploaded bin_25 along with factory reset. have 8psk installed. Dish shows signal on various birds over 70%. NO QUALITY OF SIGNAL. Line from receiver goes straight to lnb. Have tried scans on c and on L leads from lnb. No channels register. Have ip config set up. direct ethernet line to receiver. been through all the set-up with One2 two or three times. Still no channels. I have this dish on a manual adjust pole now, set at 29 degree angle. Azimuth set at 216 degrees for the 110 bird. I've scanned all 60 birds with c line hooked in only at lnb, and scanned all 60 birds with L line hooked in only at lnb. No channels have registered. Is there a new iks bin file available past #25? Menu is up, everything looks great, just no quality. Don't even have the chieta switch in the middle of lnb and receiver. Should pick up something. Some birds around 180w get up to 94% on strength, but no quality. Also, when scanning, the green line on right flashes up to 98% for various channels, but none ever register in. Can you tell me what affects this quality registration issue the most? If lnb was bad, I wouldn't get any signal strength readings at all right? Please help. dw

Did you attach loop though cable to board and IF Out on box. Take a look at this link and check out last picture attached with that post >>> NFusion HD Nuvenio Module Installation Help

__________________


Please don't PM me with fta related questions, they will no longer be answered.