Pansat Satellite Receiver 2500A Data Transfer (Receiver to Receiver)

*** Connect the Master & Slave receivers by using RS-232 (Null or Twisted) cable ***

Step #1- Version Transfer

Connect the master receiver to the TV
Press the MENU button
Go to “USER SETUP” and press “OK”
Go to “SW TRANSFER” and press “OK”
Press “CH *” button to start transfer (Once the transfer is completed, the audio in the TV unit will release two popping sounds together with the menu OSD)
*** If the percentage bar does not count, reset both the master & slave receivers and check the cable the cable connections again ***

Step #2 – Factory Setting (Master Default List)

Connect the slave receiver to the TV
Press the MENU button.
Go to “FACTORY SETTING” and press the “OK” button
Press the following buttons in your remote control to begin transfer: “Menu” – “i” – “1” – “6” – “6” – “8” (Total of six buttons)
The OSD will read “PLEASE WAIT” for a few seconds (Once the transfer is completed, the audio in the TV unit will release two popping sounds together with the menu OSD)
*** The new version will be updated in the factory default channel data condition by following these steps ***

Step #3 – Channel data transfer

Connect the master receiver back to the TV
Press the “MENU” button
Go to “USER SETUP” and press the “OK” button
Go to “SW TRANSFER” and press the “OK” button (“VER.CODE” will appear)
Press the “VOL ®” button to start transfer
Press the “CH *” button to start transfer
Once the transfer is completed, the audio in the TV unit will release two popping sounds together with the menu OSD.