I have an odd problem and will back ground the situation first.

I set up 360 a month ago per the instructions here. Every thing worked great. I did have trouble getting EPG to work but that was no big deal to me. Good signal and quality(above 80) on 110 and 119.

Last night I moved the box from my living room to bed room and hooked it up got no signal figured it was a wiring issue. This morning I moved it back and hooked it up did a full reset and started from scratch also used files SV360 Premier_V0119P Clean syst files 06-02-08 and Sonicview SV-360 Premier Factory Firmware to update the system then started a full set up. Ok when I get to dish settings I get full signal and strenght from 110 and none from 119 I do the scan and it works fine. then I loose the signal and can't get it back till I do a full factory reset again. Signal lasts about 5 min.

Any Ideas or help would be greatly apreciated.

Sounds like wiring to or from the Diescq switch might be loose or it might be the switch that is bad. I would check the connection from the LNB's to the switch and also the cable going from the switch to the receiver. If all the cables are tight and not damaged i would try a new switch.

__________________


Please don't PM me with fta related questions, they will no longer be answered.