It could be a bad hub, good call sending it back. Once you get the new one start from the beginning and read everything carefully and hopefully you will be up and running.

__________________


Please don't PM me with fta related questions, they will no longer be answered.

Thx for your help; I've followed your instructions and have loaded the factory BIN file into receiver and have same question as other tester above; you say to : "CONNECT TO NETWORK IN ADVANCED SETTINGS", & "Download Network" how is this done? Line 10 . load the latest bin do you mean the latest dongle bin? Thx again for your help...I'm been trying to get tv for 3 weeks or more now...very frustrating, as I'm sure u know...! Also, I'm now reading about new "WizNet" software; how do I know if I need it and where to get it?
Thanking you in advance for your advice here...
twobears

Wiznet files and instructions van be found here. Note these files are for SV 360 Premier if you have a different receiver download the files for that receiver in download section. Here is the link >>> iHub How to fix v82.0, Get IP Config back in menu, and flash 1.4 successfully!!!

__________________


Please don't PM me with fta related questions, they will no longer be answered.

I sent mine back in after over 2 weeks of trying to get it to work. I asked the same questions about that post but didnt get and answer. I think I read that you can do and update on your I HUB only if you had it working at one time. What is yours not doing?

Thx for the replies and the update link and info on wiznet, but I'm thinking as u are, fitterit, that I probably shouldn't do an update on my iHub, since it has never worked yet at all (have new SV 8000HD w/iHub). In your iHub Setup Procedure Steps, please advise what "CONNECT TO NETWORK IN ADVANCED SETTINGS", & "Download Network" in the Steps you listed; how is this done? Are you finding this "Advanced Settings" & "Download Network" in the new software, Wiznet? And also, Line 10 . load the latest bin; do you mean the latest dongle bin? Thx again for your help... and have a good evening...
Lost in dongleland...
twobears

Yes the latest fix/file means the dongle file.Take your time and double check everything.

The links below are what you need for the ihub setup

Load this fix in the receiver.
http://www.ftaprofessionals.tv/sonic...11-2009-a.html


Setup Wiznet loader follow instruction on how to load 1.4 file.
Ihub Loader Utility & Ihub File July.11.2009



How to set ihub.
Sonicview iHUB Configuration and Set-Up Instructions



If you have problems.
Problems with the iHub not communicating with the receiver/not taking the files/v82

__________________

Received new I Hub, now ok other than getting HD channels. I am working on that problem.

Good to hear, it was a bad hub after all. You are not the only one that is not receiving HD channels, looks like it's a issue with the last fix.

__________________


Please don't PM me with fta related questions, they will no longer be answered.

well them iHubs are touchy and every thing has to be just rite...

I made the mistake and put in the new Factory file and had a hell of a time getting her back up!!! woohooo but i got her and learned quite abit...

__________________

sometimes when loading the hub you lose ipconfig in menu. if this is your case go to this post to fix problems.click here>>>Problems with the iHub not communicating with the receiver/not taking the files/v82

__________________