You can always try factory reset and rescan your sats,SV is running very well with new files.

__________________


Please don't PM me with fta related questions, they will no longer be answered.

I left the unit on all night on DHCP and I still have a scrambled signal. everything seems to check out alright any ideas???

If you did load it yes you would.But don't its a old factory and not needed.Update ihub to 2.1 with wiznet tool and load dongle fix into the receiver.

__________________

Edenny the new files is working very good so we know it got to be something on your end, maybe try a factory reset using the remote control than load the factory file than the new fix. Do a blind scan and try again. If you have a internet connection that should get you going.

__________________

• Want to know when the new FTA Fix files are posted?
• General Helpful Hints on Forum Posting

After your advice to put the box on an active cnl, and IP Config on DHCp
I used cnl 200 and left it all night. everything shows as correctly installed
2.1 in wiznet and 417 on box. can't think of anything else to try. I sure
would appreciate some advice

I installed factory firm ware, the lastest bin, still no good. loaded fix 263 and checked the serial number--it's OK then loaded the 417 fix again. do you think
it would work if I loaded the old number in wiznet (1.9) and the old 411 fix. just to try and start again from scratch? it was working before

You should be able to go back with 1.9.But I think you would have better luck going with the new files.

After you update ihub to 2.1 and load the 417 into receiver.Rest your router then boot up receiver.Try a active cnl where you see the amber/yellow light on ihub blink frequently.If no blinks change cnls.

__________________