1) Turn OFF the receiver and unplug the power from the outlet
2) Unscrew 5 screw (2 on each side, and 1 in the back) to remove the case cover
3) Remove the module bracket
(after the bracket been removed)
4) Remove the sticker in the rear
3) Connect 2 cables to the sub-board
4) Connect the sub-board to the module .
Please be careful that Parts mounted surface should be up.
5) Connect LNB Power cable from the power supply board to the sub-board connector.
6) Connect the cable with the smaller connector from the sub-board to the connector of PCB
Please make sure the red cable should be in #1 pin.
7) Connect the cable with the smaller connector from the sub-board to the connector of PCB
Please make sure the red cable should be in #1 pin.
8) Fit the module thru the hole(reserved for the UHF remote antenna)in the rear of the receiver tight it
up using nut & washer
9) Connect a loop thru cable connecting the IF Output and the module input
10) Finishing job

Attached Files

How to install 8psk adapter and the 8psk module to the Viewsat 9000HD.zip (363.6 KB, 58 views)

Go to the Menu
Go to User Settings
Go to System Settings
At the bottom, you will now have the option to turn the External Tuner "ON". Do this.
I don't think this is necessary, but it's what I did... Factory Default to get rid of all current channels.
Go to Antenna Settings and setup your lnb/switch combinations.
Do "Auto Scan" on each of your sats individually.

This should get you what you want. Now enjoy TV, HD style!

Instructions with pictures are attached.

Attached Files

8PSK ribbon isolation and fan modifications.pdf (473.3 KB, 56 views)