The steps below are to be used when loading factory software with a .bin file extension. The latest factory file (V104) has a .all file extension and can be loaded using the USB flash device method.

#1 ‐ Make sure the VS‐Pro is turned off using the switch on the back.

#2 ‐ Connect the VS‐Pro to the COM port of your Computer using the supplied null modem cable.

#3 ‐ Start the VS‐PRO Loader Program

#4 ‐ Verify that your Com port setting in the VS‐Pro loader software is the correct port.

#5 ‐ Click "Connect".

#6 ‐ Click "Upload to STB".

#7 ‐ For File Types click on "All types" so that the ".bin" files are available to be seen.

#8 ‐ Browse to the folder where your .bin file is located and select the *.bin file that you want to flash.

#9 ‐ You'll now get a new dialog that says "Reset your STB(s)"

#10 ‐ Turn on your VS‐Pro by the switch on the back.

#11 ‐ You'll now get a new Dialog that says "Check displayed message ('Loader or 'mon') on the front panel, then press the OK button." Verify that the front of the receiver says "mon" and then click OK. It will start reflashing by erasing the memory. It will start with step (1 of 5) and will proceed with all 5 steps. Each step will take a little bit longer. The fifth step takes the longest so don't worry if it seems like it is taking awhile.

#12 ‐ Once it finishes it will say that the operation is Complete/Successful. You can now disconnect you null modem cable.